Vinyl Application Procedures:

~ You can choose to apply vinyl in one of two ways: Dry or Wet. Applying vinyl lettering or graohics dry does not allow for any mistakes. Once the vinyl touches the surface, there is no removal without damamge to the vinyl.

~ Applying vinyl lettering or graphics with anapplication spray allows you the opportunity to remove and reposition the vinyl as needed for up to several minutes. For obvious reasons, this method is recommended for both beginners and experts. To apply using an application spray, spray the surface thoroughly. Then lay the vinyl on a flat surface and spray the adhesive side as you remove the backing. An extra set of hands is a good idea. Then simply apply the vinyl to the surface.

~ Do Not excessively stretch the vinyl during the application. This is the main cause of end left. Pull the vinyl only as taut as necessary to keep a straight line. Because vinyl is pressure-sensitive product, a squeegee should be used for all installations. The purpose of using a squeegee is to remove the excess fluid and or air from behind the vinyl. You should always start the squeegee from the middle and either use a straight up or down motion. Allow the vinyl to set for 5 to 15 minutes.

~ When removing the application tape, always pull slowly, back onto itself, at a 180-degree angle. Bubbles should be punctured using a pin. Do not slit the vinyl to release the air. If the vinyl is slit it will spread or gap. The cutting or trimming of any stripe or graphic should be done using a very sharp knife and very little pressure.

*** An application spray consists of a mild soapy water. ***